Home › Services › Auger Cast Piles

Auger Cast Pile (ACIP) Installation in East Texas & DFW

Continuous-flight auger piles: high production rates, no open excavation, minimal vibration — ideal for caving sands, high groundwater, and tight urban sites.

Call (903) 681-3999 Request an Estimate

How Auger Cast Piles Work

An auger cast-in-place pile is drilled with a continuous-flight hollow-stem auger to design depth. As the auger is withdrawn, structural grout is pumped under pressure through the stem, filling the hole from the bottom up so the soil never has a chance to cave. Reinforcing steel is placed into the fluid grout column. The result is a deep foundation installed quickly, with no temporary casing, no slurry handling, and very little vibration or spoil.

When ACIP Beats a Drilled Shaft

Caving or wet groundThe grout column supports the hole — no casing or slurry program needed in running sands or high groundwater.
Production schedulesDozens of piles per shift on the right site — well suited to warehouses, mid-rise buildings, and solar or industrial projects with big pile counts.
Vibration-sensitive sitesNear hospitals, occupied buildings, or old structures where driven piles are off the table.
Noise limitsFar quieter than pile driving — friendly to urban infill work in Dallas, Fort Worth, and Tyler.

Our ACIP Capability

We install auger cast piles for commercial, industrial, and energy-sector projects across East Texas and the DFW metroplex, working from your structural design and geotechnical report. Where a project mixes pile types, we also self-perform drilled shafts and micropiles, so the whole deep-foundation package stays with one crew and one schedule. Based in Henderson County, we mobilize quickly anywhere within 150 miles of Athens — Tyler, Dallas–Fort Worth, Waco, and the I-20 corridor.

Frequently Asked Questions

What sizes and depths are typical for ACIP piles?

Common diameters run 12 to 24 inches, with depths commonly in the 30 to 80 foot range depending on soil profile and design loads. Your geotechnical engineer sets the tip elevation; we install to it and document grout volumes for every pile.

Are auger cast piles cheaper than drilled shafts?

On sites with caving soils or groundwater — where a drilled shaft would need casing or slurry — ACIP is often the more economical choice, especially at higher pile counts where production speed pays off. On small-count projects in stable clay, a conventional drilled pier is usually cheaper. Send us the boring logs and we'll price both ways.

Do you provide installation records?

Yes. Grout take, injection pressure, and depth are logged per pile, supporting your engineer's QA requirements and project closeout documents.

Need pricing on your next project?

Send us your plans and boring logs — most bids turned around fast.

Call (903) 681-3999 Email Your Plans